Quantcast
Channel: Precision Farming & GPS
Viewing all 1716 articles
Browse latest View live

Rangepoint RTX equivalent on Novotel

$
0
0
Our old fendts ran range point RTX on Trimble cfx 750 screens however our new ones have built in autosteer using Novatel. Which service would be the equivalent? We used rangepoint for drilling and it was spot on. Thanks in advance.

Dan

Software to support VarioDoc.

$
0
0
What software do people run to support Fendt VarioDoc ?
Not needing anything too elaborate.
Just wanting to create maps and coverage to back up proof of placement for farming clients who we will be applying spray, fertiliser and muck.

How to tell if a John Deere 6r is autotrac ready ?

$
0
0
How can you tell if a John Deere 6r 2017, is autotrac ready or just greenstar ready?

Leica mojortk sim card

$
0
0
Hi I realise the Leica Mojortk system is old now. I bought a used tractor with the system fitted, to be honest I was quite dissapointed with it last year compared to my John Deere system with the electric steering wheel fitted to another tractor. It has been suggested to me part of the poor performance could be the mobile coverage in our area, so I have just purchased a anywhere sim which I understand searches for the strongest of 3 different network providers.

Sim has arrived, I have...

Leica mojortk sim card

Transferring boundaries and AB lines between trimble and case?

$
0
0
We have trimble FMX gps in some of our tractors and also a Case Puma with GPS through the pro 700. Is it possible to transfer field boundaries and AB lines ect between the two systems?

Varioguide serial interface cable.

$
0
0
Apologies in advance as technically this is a hardware issue rather than a Precision Farming question.
Is anyone using the Varioguide D-sub 9 pin connector in the roof of their Fendt tractor?
We are finding the locking nuts project quite a bit lower than a standard plug and the new cable we have barely makes any contact when attached.
Are all D-sub plugs a standard size?

Trimble fm 750 + ez steer

$
0
0
My Trimble 750 won't lock on to auto steer mode . I can have the tractor on line and the red steering wheel will not change to yellow to show that it is ready to switch to auto steer .
It has been mucking around for the last few days but often would work if I turned the monitor off and disconnected the power supply .
Any suggestions please ?

JD iTc/3000 receiver updates

$
0
0
What's the definitive future for these? Are they being switched off? If so how long we got to upgrade?

Drilling headlands

$
0
0
I’ve a novatel system on ntrip and while drilling the headlands can’t make it go straight into the corners it just rounds them off. Can anyone else do this or is it just a quirk of gps feels less than pressision in the corners and can’t see markers in the stubble or my last pass very well

Ez steer controller???

$
0
0
Will an ez steer controller run a proportional steering valve?

Found one without the motor so trying to find a wiring diagram without much luck.

Trimble leads

$
0
0
Is there a cheap way of making or buying power and satellite leads or is out best just to buy then from am agent?

iPhone apps for guidance

$
0
0
I am looking for some guidance for my quad bike for slugpelleting are there any good apps out there

Trimble ez steer

$
0
0
Anyone know of a second hand ez steer system to fit a Trimble 250 screen? I have tried wanted section but no joy.
Please move mods if not allowed in this section.
Thanks

Losing satellites under trees

$
0
0
What, if anything can be done?
Can the signal be bounced with a repeater?

How to renew an RTX Rangepoint subscription?

$
0
0
Have got a code from the dealer, but not sure how to go about this on a Trimble 750. Any help with the sequence would be great thanks! Andrew.

Trimble Rangepoint or Centerpoint?

$
0
0
Hello,
I want to upgrade my Trimble receiver from EGNOS to another signal. Is Rangepoint enough for seeding or I would need Centerpoint? Thanks

Trimble headlands

$
0
0
829085


Why on earth can't these GPS screens actually put the path where they should be in the headland's.
Made a nice square corner and the fecker went and put a ruddy great wide bend in it.
Pretty pish if you ask me.
Straight lines, no problems, headlands, useless.

Xcn1050 and EZ pilot wandering steering

$
0
0
I have a New Holland XCN 1050 with EZ pilot fiitted to my New Holland combine using rangepoint rtx. It is moving 0.4-0.5m off track consistently leaving Waves everywhere. I have repositioned the nav 900 3 times, no difference. Recalibrated consistently, no difference. I have upgraded to centrepoint fast rtx with the equivalent unlock codes. Again no difference. I would appreciate all and every opinion on this. Can I do a hard reset and keep my liscences ? At the moment they are on a 10 day...

Xcn1050 and EZ pilot wandering steering

Teejet Matrix Pro 570gs versus Pro 840gs

$
0
0
What is the difference between these two monitors except the size and £ 400 for the larger screen .
Has anyone used both and is the extra cost worth it ?
The spec looks virtually the same or have I missed something ?

NTRIP and Mobile Internet

$
0
0
I have been looking again at some of the less mainstream offerings such as Fieldbee and I am wondering how close the RTK connection broadcast needs to be based, to allow accurate location adjustments, when received over the Internet?

10km, 100km?? I assume you need the same satellites need to be connected to the GPS Receiver AND the RTK adjustment receiver base?
Viewing all 1716 articles
Browse latest View live